NAEF Punch Presses D-42 and iso cutting dies
   

Cutting Dies and Punch Press Manufacturing since 1909
Paper * Plastics * Cardboard * Textiles * Rubber or any Soft Material

Manual Punch Press Model D-42

 
Specifications
 
NAEF USA home Page
NAEF USA Presses
NAEF USA Cuitting Dies
NAEF USA Die Sharping
Band-All automatic label banding
Capacity
Max. Lineal cutting edge
Projection
Piston Stroke
Die Opening
Die holding dia.(pressure plate)
Table Width
Table Depth
Machine Height
Machine Width

Machine Depth
Net Weight
Shipping Weight
13,480lbs
70"
7-7/8 "
9/16"
11/16"
7-1/2"
13-7/8"
11-7/8"
23-1/4"
19-5/8"
31-1/2"
278 lbs
392 lbs

 

 

NAEF Manual Punch Press D-42

The NAEF D-42 Punch Press is used in Laboratories, Quality Control and the R & D Dept. The D-42 cuts soft material including textile, carpets, paper, plastic, rubber etc. . . The maximum sample thickness is 1/2 inch. The die is supported securely to the clamping chuck(Pressure plate and Gripper) and stays in place during cutting and removal of the samples. Changing dies is a matter of seconds. All NAEF dies come with an expulsion, so that the samples will be found flat on the table every time. The depth gauge prevents penetration into the table top surface.
we accept Master Card
NAEF Press & Dies, Inc.
2 Braley Point Road
P. O. Box 1249
Bolton Landing, New York 12814-1249
we accept VISA
  Phone: (518) 644 - 2018
Fax: (518) 644 - 2546
 
NAEF Home Page
Pneumatic Punch Press P-44
Manual Punch Press B-36
Manual Punch Press D-42
Die Sharpening

E-mail us
Cutting Dies
NAEF Presses
ASTM Dies
banding products
Copyright ©2000-2001 NAEF Press & Dies, Inc. All rights reserved. Information in this document is subject to change without notice. Other products and companies referred to herein are trademarks or registered trademarks of their respective companies.
Site designed and maintained by